Page 1 of 1
Upgraded DSM to 6.1.3-15152, NZBGet won't start
Posted: 17 Jul 2017, 12:41
by charsiufan
Hi All
Just upgraded my Synology DS1815 to DSM 6.1.3-15152 and after reboot NZBGet won't start. I can't find a thread that addresses a similar issue so apologies if its been asked before. Any troubleshooting advice is appreciated.
NZBGet version is: 16.4-22
Thanks
Re: Upgraded DSM to 6.1.3-15152, NZBGet won't start
Posted: 17 Jul 2017, 13:27
by charsiufan
Ok, to give an update. I decided to do a reinstall but after uninstallation I couldn't find a package in SynCommunity.
I found a version 19-23. Installed that and it ran. I configured it, seemed to be working well, but then it stopped.
Now I can't even start NZBGet after an uninstall / fresh install
Re: Upgraded DSM to 6.1.3-15152, NZBGet won't start
Posted: 17 Jul 2017, 16:36
by hugbug
This is very synology specific issue. Therefore hard to give advices whithout having a similar device.
What you could do is to install nzbget using official installer from nzbget download page by following the manual (installation on linux) linked on download page.
Re: Upgraded DSM to 6.1.3-15152, NZBGet won't start
Posted: 17 Jul 2017, 17:57
by charsiufan
Thanks I'll take a look.
Can anyone suggest where i might find the logs?