Getting to grips with NZBGet after having previously been a SAB user. I swapped simply because eI was told NZBGet would be less processor hungry.
Initially I had an issue with downloads not being auto repaired, could not find the issue so I just deleted the docker image and started again, with exactly the same settings, all worked as expected.
The only issue I have now is that when I give NZBGet a list fo file sot grab, it appears to grab them a tiny bit faster than SAb did but it ends up with a lot fo the files sat labelled PP-Queued, it doe process them but appears to take longer overall to get the files, processionals them and then unpack the. Is there a way to force the system to auto unpack as it goes along? It honest appear to.
Just to confirm again. My setup is as follows
Docker image from Linux io
6GB ram assigned to the container with no processor limitations
Seperate drives attached to the intermediate and final destinations
Anyway I can improve the processing? SAB seemed to do it all in one go and not queue things up for processing and unpacking later.
Thanks for reading!