Hello clinton. I've finally decided to switch to nzbToMedia. Have a few questions that I have have mentioned in this post. Thanks for your help as always.
Update: I think my post got moved here
Hi Clinton / someone else who might have a suggestionclintonhall wrote:2 options...
for option 1, your settings can be imported... however you would still need to add the correct host, port, user, pass etc in the config of nzbToMedia shown in NZBGet web UI (so actually, the migration would be rather pointless). I forgot that I did the migration BEFORE allowing the settings to be specified in NZBGet WebUI...
So, option 2 is probably what you want. Just edit the sabToSickBeard.py as per mys post, then when you point NZBGet to this scripts folder, you should see the sabToScikBeard.py script.
The settings should be as per your existing autoProcessTV.cfg
Give it a go and let me know if you have any issues (I never had a chance to test it)
Thanks. I got to the same conclusion, but unfortunately my scripting skills are not good enough that I know where to put it in the script clintonhall posted on the first page.hugbug wrote:NZBGet expect a correct exit code from the script. Please see https://github.com/nzbget/nzbget/wiki/P ... exit-codes
Code: Select all
sys.exit(93)
Haha. Well. that was simpler than what I had tried. I had put it on several locations, but apparently I didn't try the most obvious place.hugbug wrote:Try adding as a new line at the very end:Code: Select all
sys.exit(93)
Users browsing this forum: No registered users and 29 guests